Kmc-controls MCP-1160 Series Manual de usuario descargar pdf

Installation Guide

6” Pneumatic Damper Actuator

MCP-1160 Series

Mounting

The MCP-1160 MUST be mounted on a rigid

surface due to the force generated at, or near,

maximum air pressure.

1. Align the actuator with the controlled device.

The mounting joint allows the actuator to be

located in a different plane from the controlled

device.

2. Attach the actuator to the rigid surface through

the four 3/8" (4 mm) holes in the mounting

bracket.

3. Adjust the crankarm assembly from 60° to 120°

rotation as required.

4. DO NOT tighten the universal joint. The

actuator must be free to swivel as it operates.

Connections

MCP-1160 models ordered with positioners are

factory piped.

♦ Use 1/4" (6 mm) O.D. FR polyethlyene tubing.

♦ Use only clean, dry control air. No attempt

should be made to use any other medium.

1 Connect the actuator input to the positioner

output, Port “1”.

2. Connect the input signal to the positioner to Port

“2”.

3. Connect the main air (20 psi) to the center port.

NOTE: If the application requires operation near

the maximum temperature and maximum

pressure, add a tubing restraint to the actuator

connection.

1 2

Installation Guide6” Pneumatic Damper ActuatorMCP-1160 SeriesMountingThe MCP-1160 MUST be mounted on a rigidsurface due to the force generated at, or

KMC Controls19476 Industrial DriveNew Paris, IN 46553 574.831.5250www. kmccontrols.com016-019-01Adjustments and CalibrationDANGERThe MCP-1160 contain

Sin comentarios

Kmc-controls MCP-1160 Series Manual de usuario