Kmc-controls TSP-6051 Manual de usuario descargar pdf

TSP-6001/6051 1 Installation Guide

Installation Guide

Air Flow Transducer-Actuators (3-State Analog)

TSP-6001/6051

Mounting 1

Standard Instructions 1

HFO-0011 Adaptor 1

Connections and Wiring 2

Setup 2

Calibration 2

Maintenance 2

Important Notices 2

Sample Application 3

NOTE: See the data sheet for a complete listing of

accessories as well as specications.

HFO-0011

Adaptor

Mounting

The TSP-6001/6051 is designed to mount directly to

a 1/2" diameter shaft, a 3/8" square damper shaft, or

(with an optional HFO-0011 shaft adaptor) a 3/8"

diameter shaft.

Standard Instructions

1. Slide the TSP-60x1 directly onto the 1/2 in.

diameter damper shaft. The shaft must extend a

minimum of 1-3/4 in. from the mounting surface.

(For a 3/8 in. shaft, see HFO-0011 Adaptor on

page 1.)

2. Place the non-rotation bracket (supplied) on the

non-rotation tab. Leave a gap of 1/8" between the

boom surface of the TSP-60x1 and the bracket to

allow for play during operation (see illustration).

3. Aach the non-rotation bracket to the mounting

surface using (2) #8 or #10 self-tapping screws

(not included).

4. Depress the gear disengagement buon and:

A. Rotate the drive hub until the indicator stops

at the “90” mark if the damper is clockwise to

close.

B. Rotate the drive hub to the “0” mark if the

damper is counterclockwise to close.

5. Position the damper to full open.

6. Torque the two 5/16-18 set screws 75 to 85 in-lb.

7. Depress the gear disengagement buon and

rotate the drive hub/damper to the closed

position.

8. Loosen the adjustable end stop, position against

the damper position indicator, and retighten.

HFO-0011 Adaptor

1. Mount the TSP-60x1 over the 3/8 in. shaft.

2. Slide the HFO-0011 over the shaft into the drive

hub of the actuator.

3. Align the adaptor slots with the set screws.

4. Partially tighten the set screws.

5. Continue with Step 2 under the Standard

Instructions section above.

1 2 3

Indice de contenidos

Pagina 1 - Installation Guide

TSP-6001/6051 1 Installation GuideInstallation GuideAir Flow Transducer-Actuators (3-State Analog)TSP-6001/6051 Mounting 1Standard Instructions 1

Pagina 2 - Maintenance

TSP-6001/6051 2 Installation GuideConnections and WiringWiring DetailSetupThe TSP-6001/6051 is factory calibrated to function with the SSS-1002 thro

Pagina 3 - Sample Application

Modelos relacionados TSP-6001

Comentarios a estos manuales

Sin comentarios

Kmc-controls TSP-6051 Manual de usuario

Busca en linea o descarga Manual de usuario para Sensores Kmc-controls TSP-6051. KMC Controls TSP-6051 User Manual Manual de usuario

Indice de contenidos

Modelos relacionados TSP-6001

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Kmc-controls TSP-6051