Kmc-controls MEP-4842 Manual de usuario descargar pdf

MEP-4042/4842 1 Installation Guide

Installation Guide

Direct-Coupled ControlSet

Actuators (40/80 in-lb.)

MEP-4042/4842

Mounting 1

Connector Pin Voltage Reference 1

Wiring 2

Maintenance 2

Mounting

1. Ensure the damper can move freely through its

entire range of motion, and x any binding before

installing the actuator. Turn the damper blade to

its fully closed position.

2. Press (to the right) and hold the gear

disengagement lever (see the illustration above),

rotate the actuator to the fully closed position,

and release the lever.

NOTE: Depending on the damper-seal design,

backing the actuator o its stop

approximately 5° may provide tight

damper shut-o.

3. Align the actuator and slide it onto the shaft.

4. Leaving a gap between the actuator and

mounting surface to prevent any binding, nger-

tighten the nuts on the V-bolt.

5. Insert the non-rotation bracket (HMO-4002

supplied or HMO-4001 “T” bracket available

separately) into the slot at the base of the actuator.

(See the illustration above).

[135]

5.300

3.700

ADJUSTABLE

STOP

PIN 1

PIN 6

1.568

39.8

2.600

[63.5]

2.500

NON-ROTATION BRACKET

PROVIDED (HMO-4002)

GEAR DISENGAGEMENT

LEVER

6. Secure the non-rotation bracket with two (2) #8 or

#10 self-tapping screws.

7. Evenly tighten the V-bolt nuts 30 to 35 in-lbs. on

the MEP-4042, or 60 to 70 in-lbs. on the MEP-4842.

8. If desired, use a 7/64-inch hex key wrench to

loosen and position the end-stop screw.

NOTE: The two holes at the top of the actuator

are NOT for use in direct-coupled

applications. They are for remote mounting,

such as with the optional HLO-4001 Crank

Arm Kit (see the installation guide for the

MEP-4000/4800 series actuators).

Connector Pins* Function

1 and 6 ~ 24 VAC (phase side)

2 and 5 Common

3 17.4 VDC out @ 10 mA Max. (powers CTE-5201-16)

4 Signal input (2–10 VDC)

*See the pin designators in the lower left of the illustration above.

Connector Pin Voltage Reference

1 2

Installation Guide 1
Maintenance 2

Indice de contenidos

Pagina 1 - Installation Guide

MEP-4042/4842 1 Installation GuideInstallation GuideDirect-Coupled ControlSet® Actuators (40/80 in-lb.)MEP-4042/4842 Mounting 1Connector Pin Voltag

Pagina 2 - Maintenance

Modelos relacionados MEP-4042

Comentarios a estos manuales

Sin comentarios

Kmc-controls MEP-4842 Manual de usuario

Busca en linea o descarga Manual de usuario para Sensores Kmc-controls MEP-4842. KMC Controls MEP-4842 User Manual Manual de usuario

Indice de contenidos

Modelos relacionados MEP-4042

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Kmc-controls MEP-4842