
KMC Controls
Revision A6
Rough-in preparation
To prevent mounting screw heads from touching the circuit
board in the NetSensor, use only the mounting screws
supplied by KMC Controls. Using screws other than the
type supplied will damage the NetSensor.
Complete rough-in wiring at each sensor location prior to sensor
installation. This includes the following.
◆ Routing the network cable from the NetSensor to a controller.
◆ If required, installing the appropriate backplate. See Accessories
on page 3 for model numbers.
NetSensor mounting details
RJ-12
cable
Allen
screws
Mounting
base
Comentarios a estos manuales